Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated) [02/2024 - ]: Procedure

1. Check whether the jam protection function malfunctions while performing the auto up function.

   Refer to OPERATION CHECK [02/2024 - ]

   Result

   Result	Proceed to
   The jam protection function malfunctions and the door glass does not fully close.	A
   The jam protection function malfunctions and the door glass fully closes.	B

Result: 

B 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [02/2024 - ] 

Result: 

A 

See step  2

1. Perform initialization of any power window regulator motor assembly which did not fully close.

   Refer to REGISTRATION [02/2024 - ]

2. Check whether the jam protection function malfunctions while performing the auto up function.

   Refer to OPERATION CHECK [02/2024 - ]

   OK

   The jam protection function does not malfunction.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

Result: 

NG 

See step  3

1. Check that the components related to the power window (door glass, glass runs, power window regulator, door panels, etc.) are installed correctly.

   for Front Door: Refer to DISASSEMBLY [02/2024 - ]

   for Rear Door: Refer to DISASSEMBLY [02/2024 - ]

   NOTE:

   • There is no deformation, distortion, looseness, or damage to the installed components.
   • If there is damage, perform a replacement.

   OK

   Correctly installed.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

INSTALL PARTS CORRECTLY 

Result: 

OK 

See step  4

1. Remove the bolt of the door glass and check that the door glass slides smoothly without being caught when it is moved up and down by hand.
   NOTE:

   • The door glass fits with the glass run without improper contact or deformation.
   • Foreign matter is not caught in the glass run.
   • The glass run is not misaligned.
   • The door belt moulding or door inner glass weatherstrip is not caught.
   • The glass is not tilted and does not catch.

   OK

   The door glass slides smoothly without being caught when it is moved up and down by hand.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

See step  8

Result: 

OK 

See step  5

1. Remove the door glass sub-assembly.

   for Front Door: Refer to DISASSEMBLY [02/2024 - ]

   for Rear Door: Refer to DISASSEMBLY [02/2024 - ]

2. Check operation (for Driver Door)
   1. Connect the multiplex network master switch assembly connector.
   2. Turn the ignition switch to ON.
   3. Operate the driver door switch of the multiplex network master switch assembly and check that the door window regulator with motor assembly (for Driver Door) operates smoothly.

      OK

      Operates smoothly without being caught.

3. Check operation (except Driver Door)
   1. Connect the power window regulator switch assembly or rear power window regulator switch assembly connector.
   2. Turn the ignition switch to ON.
   3. Operate the power window regulator switch assembly or rear power window regulator switch assembly and check that the door window regulator with motor assembly operates normally.

      OK

      Operates smoothly without being caught.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

See step  11

Result: 

OK 

See step  6

1. Remove the door window regulator with motor assembly.

   for Front Door: Refer to DISASSEMBLY [02/2024 - ]

   for Rear Door: Refer to DISASSEMBLY [02/2024 - ]

2. Remove the power window regulator motor assembly.

   for Front Door: Refer to REMOVAL [02/2024 - ]

   for Rear Door: Refer to REMOVAL [02/2024 - ]

3. Check that the door window regulator sub-assembly is not deformed or distorted.

   OK

   No deformation or distortion.

   Result

   Result	Proceed to
   OK	A
   NG (A jam protection function malfunction occurs at the driver door.)	B
   NG (A jam protection function malfunction occurs at the front passenger door.)	C
   NG (A jam protection function malfunction occurs at the rear RH door.)	D
   NG (A jam protection function malfunction occurs at the rear LH door.)	E

Result: 

B 

REPLACE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH. Refer to  DISASSEMBLY [02/2024 - ] 

Result: 

C 

REPLACE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY RH. Refer to  DISASSEMBLY [02/2024 - ] 

Result: 

D 

REPLACE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY RH. Refer to  DISASSEMBLY [02/2024 - ] 

Result: 

E 

REPLACE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH. Refer to  DISASSEMBLY [02/2024 - ] 

Result: 

A 

See step  7

1. Make sure to reinstall all of the removed parts.

   for Front Door: Refer to REASSEMBLY [02/2024 - ]

   for Rear Door: Refer to REASSEMBLY [02/2024 - ]

2. Initialize the power window regulator motor assembly. (applicable location)

   Refer to REGISTRATION [02/2024 - ]

3. Check whether the jam protection function malfunctions while performing the auto up function.

   Refer to OPERATION CHECK [02/2024 - ]

   OK

   The jam protection function does not malfunction.

   Result

   Result	Proceed to
   OK	A
   NG (A jam protection function malfunction occurs at the driver door.)	B
   NG (A jam protection function malfunction occurs at the front passenger door.)	C
   NG (A jam protection function malfunction occurs at the rear RH door.)	D
   NG (A jam protection function malfunction occurs at the rear LH door.)	E

Result: 

A 

END (CAUSED BY INCORRECT ASSEMBLY) 

Result: 

B 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (for Driver Door). Refer to  REMOVAL [02/2024 - ] 

Result: 

C 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (for Front Passenger Door). Refer to  REMOVAL [02/2024 - ] 

Result: 

D 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (for Rear RH Door). Refer to  REMOVAL [02/2024 - ] 

Result: 

E 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (for Rear LH Door). Refer to  REMOVAL [02/2024 - ] 

1. Remove the door glass sub-assembly.

   for Front Door: Refer to DISASSEMBLY [02/2024 - ]

   for Rear Door: Refer to DISASSEMBLY [02/2024 - ]

2. Check that nothing catches in the glass run in the sliding parts area, and that there is no foreign matter.

   OK

   Nothing catches, and no foreign matter.

   Result

   Result	Proceed to
   OK	A
   NG (A jam protection function malfunction occurs at the driver door.)	B
   NG (A jam protection function malfunction occurs at the front passenger door.)	C
   NG (A jam protection function malfunction occurs at the rear RH door.)	D
   NG (A jam protection function malfunction occurs at the rear LH door.)	E

Result: 

B 

CLEAN OR REPLACE FRONT DOOR GLASS SUB-ASSEMBLY (for Driver Door) 

Result: 

C 

CLEAN OR REPLACE FRONT DOOR GLASS SUB-ASSEMBLY (for Front Passenger Door) 

Result: 

D 

CLEAN OR REPLACE REAR DOOR GLASS SUB-ASSEMBLY (for Rear RH Door) 

Result: 

E 

CLEAN OR REPLACE REAR DOOR GLASS SUB-ASSEMBLY (for Rear LH Door) 

Result: 

A 

See step  9

1. Remove the door glass run.

   for Front Door: Refer to DISASSEMBLY [02/2024 - ]

   for Rear Door: Refer to DISASSEMBLY [02/2024 - ]

2. Check that nothing catches the glass sub-assembly in the sliding parts area, and that there is no foreign matter or deformation.

   OK

   Nothing catches, and no foreign matter or deformation.

3. Check that there is no foreign matter or deformation of the installed components of the glass run.

   OK

   No foreign matter or deformation.

   Result

   Result	Proceed to
   OK	A
   NG (A jam protection function malfunction occurs at the driver door.)	B
   NG (A jam protection function malfunction occurs at the front passenger door.)	C
   NG (A jam protection function malfunction occurs at the rear RH door.)	D
   NG (A jam protection function malfunction occurs at the rear LH door.)	E

Result: 

B 

CLEAN OR REPLACE DOOR GLASS RUN OR DOOR GLASS RUN MOUNTING PARTS (for Driver Door) 

Result: 

C 

CLEAN OR REPLACE DOOR GLASS RUN OR DOOR GLASS RUN MOUNTING PARTS (for Front Passenger Door) 

Result: 

D 

CLEAN OR REPLACE DOOR GLASS RUN OR DOOR GLASS RUN MOUNTING PARTS (for Rear RH Door) 

Result: 

E 

CLEAN OR REPLACE DOOR GLASS RUN OR DOOR GLASS RUN MOUNTING PARTS (for Rear LH Door) 

Result: 

A 

See step  10

1. Make sure to reinstall all of the removed parts.

   for Front Door: Refer to REASSEMBLY [02/2024 - ]

   for Rear Door: Refer to REASSEMBLY [02/2024 - ]

2. Initialize the power window regulator motor assembly. (applicable location)

   Refer to REGISTRATION [02/2024 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

END (CAUSED BY INCORRECT ASSEMBLY) 

1. Remove the door window regulator with motor assembly.

   for Front Door: Refer to DISASSEMBLY [02/2024 - ]

   for Rear Door: Refer to DISASSEMBLY [02/2024 - ]

2. Remove the power window regulator motor assembly.

   for Front Door: Refer to REMOVAL [02/2024 - ]

   for Rear Door: Refer to REMOVAL [02/2024 - ]

3. Check that the sliding parts area of the door window regulator sub-assembly is not deformed or distorted.

   OK

   No deformation or distortion.

   Result

   Result	Proceed to
   OK (A jam protection function malfunction occurs at the driver door.)	A
   OK (A jam protection function malfunction occurs at the front passenger door.)	B
   OK (A jam protection function malfunction occurs at the rear RH door.)	C
   OK (A jam protection function malfunction occurs at the rear LH door.)	D
   NG (A jam protection function malfunction occurs at the driver door.)	E
   NG (A jam protection function malfunction occurs at the front passenger door.)	F
   NG (A jam protection function malfunction occurs at the rear RH door.)	G
   NG (A jam protection function malfunction occurs at the rear LH door.)	H

Result: 

A 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (for Driver Door). Refer to  REMOVAL [02/2024 - ] 

Result: 

B 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (for Front Passenger Door). Refer to  REMOVAL [02/2024 - ] 

Result: 

C 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (for Rear RH Door). Refer to  REMOVAL [02/2024 - ] 

Result: 

D 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (for Rear LH Door). Refer to  REMOVAL [02/2024 - ] 

Result: 

E 

REPLACE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH. Refer to  DISASSEMBLY [02/2024 - ] 

Result: 

F 

REPLACE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY RH. Refer to  DISASSEMBLY [02/2024 - ] 

Result: 

G 

REPLACE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY RH. Refer to  DISASSEMBLY [02/2024 - ] 

Result: 

H 

REPLACE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH. Refer to  DISASSEMBLY [02/2024 - ]