DTC P0606-09: Control Module Processor (Brake Override System Output Signal) Component Failure [02/2024 - ]: Procedure
- READ OUTPUT DTC (IN ADDITION TO DTC P0606-09)
Pre-procedure1
- Turn the ignition switch to ON.
- Wait 1 second or more.
Procedure1
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to P0606-09 and other DTCs are output A P0606-09 is output B HINT:
If any DTCs other than P0606-09 are output, troubleshoot those DTCs first.
Post-procedure1
- None
Result:
B
REPLACE ECM
Refer to REMOVAL [02/2024 - ]
Result:
A
See step 2
- GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [02/2024 - ]
HINT:
After the inspection, perform the following procedure.
Result
Proceed to NEXT Result:
NEXT
See step 3
- CLEAR DTC
Pre-procedure1
- None
Procedure1
- Clear the DTCs.
Powertrain > Engine > Clear DTCs
Result
Proceed to NEXT Post-procedure1
- Turn the ignition switch off and wait for at least 30 seconds.
Result:
NEXT
See step 4
- None
- CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
Pre-procedure1
- Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
Procedure1
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTCs are not output A P0606-09 is output B Post-procedure1
- None
Result:
A
END
Result:
B
REPLACE ECM
Refer to REMOVAL [02/2024 - ]
- Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.