DTC P062F-44: Internal Control Module EEPROM Data Memory Failure [02/2024 - ]: Procedure

Pre-procedure1

1. None

   Procedure1

2. Clear the DTCs.

   Powertrain > Engine > Clear DTCs 

   Result

   Proceed to
   NEXT

   Post-procedure1

3. Turn the ignition switch off.

Result: 

NEXT 

See step  2

Pre-procedure1

1. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
2. Connect the cable to the negative (-) auxiliary battery terminal.
3. Put the engine in Inspection Mode (for measuring Exhaust Gas).

   Powertrain > Hybrid Control > Utility 

   Tester Display
   Inspection Mode

4. Start the engine and wait 30 seconds or more.

   Procedure1

5. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   P062F-44 is output	B

   Post-procedure1

6. None

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS 

Refer to HOW TO PROCEED WITH TROUBLESHOOTING [02/2024 - ]

Result: 

B 

REPLACE ECM 

Refer to REMOVAL [02/2024 - ]