Confirmation Driving Pattern

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

By performing a confirmation drive, you can confirm the reoccurrence of DTC.

1. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
2. Turn the ignition switch off and wait for at least 30 seconds.
3. Put the engine in Inspection Mode (for measuring Exhaust Gas) [A].

   Refer to INSPECTION MODE PROCEDURE [02/2024 - ]

4. Start the engine.
5. Accelerate the vehicle to 30 km/h (18.65 mph) or more, depress the brake pedal and decelerate the vehicle to 3 km/h (1.86 mph) or less [B]. Repeat step [B] 5 times.
6. Drive the vehicle at 40 km/h (25 mph) or more for 60 seconds or more [C].
7. Enter the following menus: Powertrain / Engine / Trouble Codes.
8. Read the pending DTCs.

   HINT: 

   • If a pending DTC is output, the system is malfunctioning.
   • If a pending DTC is not output, perform the following procedure.
9. Enter the following menus: Powertrain / Engine / Utility / All Readiness.
10. Input the DTC: P1610-09.
11. Check the DTC judgment result.