Removal [03/2019 - ]: Procedure
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Refer to REMOVAL [03/2019 - ]
- REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 12
- REMOVE ECM NOTE:
- Electrostatic discharge.
Damage to or destruction of electrical components.
- Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.
- For additional information see:
Refer to PRECAUTION [03/2019 - ]
HINT:
- Follow instructions for removing and installing control units.
For additional information see:
Refer to PRECAUTION [03/2019 - ]
- In a warranty case, you must always provide a fault memory printout with the defective part, even if the fault memory does not contain an entry.
- Control unit must be programmed after it is replaced.
For additional information see:
Refer to PRECAUTION [03/2019 - ]
- Disconnecting control units may cause fault code entries and functional limitations. Fault code entries must be read out and deleted if necessary.
- Electrostatic discharge.