Installation [03/2019 - ]: Procedure

Refer to PROCEDURE - Step 1

1. Install ignition coil.
2. Tighten down E8 bolt.

   Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

3. Connect connectors and lock.

   HINT: 

   The connector must engage audibly.

4. Connect the connectors (1) of the No. 2 oxygen sensor and the No. 2 air fuel ratio sensor on the cable shaft (2).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Turn the No. 1 engine cover (2) at the pivot point (1) to the installation position and guide it in where marked (arrows).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to PROCEDURE - Step 38