LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2025 >> Supra Base, Standard Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (B58) - Service Information >> Knock Sensor >> Removal [03/2019 - ] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal [03/2019 - ]: Procedure

  1. REMOVE INTAKE MANIFOLD 

    Refer to REMOVAL [03/2019 - ]

  2. REMOVE KNOCK SENSOR (for Bank 1) 
    NOTE:
    • Electrostatic discharge.

      Damage to or destruction of electrical components.

      • Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.
      • For additional information see:

        Refer to PRECAUTION [03/2019 - ]

    1. Loosen E8 bolts (1).
      GTY946397Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Detach coolant line and wiring harness from the intake manifold stay (2).
    3. Guide out and remove intake manifold stay (2).
    4. Unlock connector (1) and pull off.
      GTY946396Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Loosen E10 bolt (2).
    6. Remove the knock sensor (3).
  3. REMOVE KNOCK SENSOR (for Bank 2) 
    NOTE:
    • Electrostatic discharge.

      Damage to or destruction of electrical components.

      • Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.
      • For additional information see:

        Refer to PRECAUTION [03/2019 - ]

    1. Unlock connector (1) and pull off.
      GTY946390Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Loosen E10 bolt (2).
    3. Remove the knock sensor (3).
scientia non olet · About LEMON Manuals