Installation [11/2021 - 05/2022]: Procedure

INSTALL ECM

Install the ECM with the 3 bolts.
Torque: 13 N.m (133 kgf/cm, 10 ft.lbf)

NOTE:
If the ECM has been struck or dropped, replace it.
Attach the 2 wire harness clamps.
Connect the 3 connectors to the ECM and push down the lever to lock it.
Attach the 2 wire connector clamps.

INSTALL AIR WITH ELEMENT CLEANER ASSEMBLY LH
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 5
WRITE VIN
Refer to REGISTRATION [11/2021 - ]

HINT:

It requires when replacing the ECM.
ECU CONFIGURATION
Refer to ECU CONFIGURATION [11/2021 - 05/2022]

HINT:

It requires when replacing the ECM.
UPDATE ECU SECURITY KEY
Refer to UPDATE ECU SECURITY KEY [11/2021 - ]

HINT:

It requires when replacing the ECM.
WORK PROCEDURES AFTER PARTS INSTALLED
Refer to WORK PROCEDURE [11/2021 - 05/2022]
WORK PROCEDURES AFTER BATTERY RECONNECTED
HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Refer to AUTOMATIC LEARNING CHART [11/2021 - 05/2022]