Wireless Charger Front Removal And Installation/Replacement

Mobile Repair Possible:  Van/Car

Removal Procedure: 

1. Disconnect the 12V battery negative terminal. Refer to 12V BATTERY NEGATIVE CABLE DISCONNECTION/CONNECTION 
2. Remove Front Floor Console Cup Holder Bezel Trim. Refer to FRONT FLOOR CONSOLE CUP HOLDER BEZEL TRIM REMOVAL AND INSTALLATION/REPLACEMENT
3. Unlock and disconnect the electrical connector (1).
4. Remove 4 screws (2).

   Torque: 1.5 Nm 

5. Lift the wireless charging system (3) slightly and remove it.

Installation Procedure: 

1. Installation is the reverse of removal procedure, noting the following.

   All fasteners must be tightened to torque specification! 

2. Install Front Floor Console Cup Holder Bezel Trim. Refer to FRONT FLOOR CONSOLE CUP HOLDER BEZEL TRIM REMOVAL AND INSTALLATION/REPLACEMEN
3. Reconnect the 12V battery negative terminal. Refer to 12V BATTERY NEGATIVE CABLE DISCONNECTION/CONNECTION 
4. Diagnostics, Programming and Setup. Refer to DIAGNOSTICS, PROGRAMMING AND SETUP USING IDS IN SERVICE