LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 1980 >> Scirocco Base, Standard Trans >> Repair and Diagnosis (Single Page) >> Engine Performance >> Ignition System >> BOSCH Hall Effect Electronic Ignition System >> Testing >> Ignition Control Unit Check >> Vanagon Only
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Vanagon Only

  1. Remove connector from distributor. Connect positive lead of voltmeter to terminal 15 of ignition coil. Connect negative lead to terminal 1 of coil. See Fig 1. Turn ignition switch "ON".
    Fig 1: Voltmeter Hookup for Ignition Control Unit Operation Check (Vanagon)
    G09324711Courtesy of NOT AVAILABLE
  2. Voltage should be approximately 6 volts and then drop to zero (0) volts within 1 or 2 seconds. If not, replace ignition control unit. Also check ignition coil.