LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2014 >> Passat TDI SE, Standard Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> 1.8L - Generic Scan Tool - Engine Code: CPKA (Transmission DTC Tables) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Procedures >> Intake Manifold Runner Position Sensor - G336-, CHECKING >> Test Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Procedure

Step Procedure Result / Action to Take
1
  • PERFORM: Preliminary Check to verify the customers complaint. Refer to PRELIMINARY CHECK .
-- Was Complaint verified?
  • YES:
  • GO TO Step 2.
  • NO:
  • GATHER more information from customer about the complaint.
2
  • IGNITION: ON.
  • DISCONNECT: Intake Manifold Runner Position Sensor -G336- harness connector.
  • CHECK: Intake Manifold Runner Position Sensor -G336- harness connector terminals 1 to 3 for voltage.
  • SPECIFIED VALUE: About 5.0 V.
  • IGNITION: OFF.
-- Was Value obtained?
  • YES:
  • GO TO Step 3.
  • NO:
  • GO TO Step 4.
3
  • REMOVE: Engine Control Module - J623-. Refer to appropriate repair information.
  • CHECK: Intake Manifold Runner Position Sensor -G336- harness connector terminal 2 to the Engine Control Module - J623- harness connector T105 / 36 for resistance.
  • SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω).
-- Was Value obtained?
  • YES:
  • REPLACE: Intake Manifold Runner Position Sensor -G336-. Refer to appropriate repair information.
  • GO TO: Step 5.
  • NO:
  • CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals.
  • REPAIR: Faulty wiring or connector.
  • GO TO: Step 5.
4
  • REMOVE: Engine Control Module - J623-. Refer to appropriate repair information.
  • CHECK: Intake Manifold Runner Position Sensor -G336- harness connector terminal 1 to the Engine Control Module - J623- harness connector T105 / 48 for resistance.
  • CHECK: Intake Manifold Runner Position Sensor -G336- harness connector terminal 3 to the Engine Control Module - J623- harness connector T105 / 47 for resistance.
  • SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω).
-- Were Values obtained?
  • YES:
  • REPLACE Engine Control Module -J623-. Refer to appropriate repair information.
  • GO TO: Step 5.
  • NO:
  • CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals.
  • REPAIR: Faulty wiring or connector.
  • GO TO: Step 5.
5
  • Final Procedure
  • Perform a road test to verify repair.
  • Do any DTC's return:
  • NO:
  • Repair is complete. Generate readiness code. Refer to READINESS CODE .
  • Return vehicle to Customer.
scientia non olet · About LEMON Manuals