| 1 |
- PERFORM: Preliminary Check to verify the customers complaint. Refer to: PRELIMINARY CHECK
.
-- Was Complaint verified? |
-- YES:
-- NO:
- GATHER more information from customer about the complaint.
|
| 2 |
- IGNITION: OFF.
- DISCONNECT: Oxygen Sensor 1 Before Catalytic Converter -GX10- harness connector.
- CHECK: Oxygen Sensor 1 Before Catalytic Converter -GX10- component connector terminals 3 to 4 for resistance.
- SPECIFIED VALUE: 1 - 5 Ω (@ 25° C).
-- Was Value obtained? |
-- YES:
-- NO:
|
| 3 |
- IGNITION: ON.
- CHECK: Oxygen Sensor 1 Before Catalytic Converter -GX10- harness connector terminal 4 to ground for voltage.
- SPECIFIED VALUE: Battery voltage.
- IGNITION: OFF.
-- Were Values obtained? |
-- YES:
-- NO:
|
| 4 |
- RECONNECT: Oxygen Sensor 1 Before Catalytic Converter -GX10- harness connector.
- CONNECT: Scan Tool.
- START: Engine and let Idle.
- Perform the function test located in diagnostic mode 06. Refer to appropriate Diagnostic Mode 06 - Read Test Results for Specific Diagnostic Functions, DIAGNOSTIC MODES 01 - 09
.
- SPECIFIED VALUE: Mode 6 Pass.
- IGNITION: OFF.
-- Were Values obtained? |
-- YES:
-- NO:
|
| 5 |
- REMOVE: Engine Control Module -J623-.
- CHECK: Oxygen Sensor 1 Before Catalytic Converter -GX10- harness connector terminal 1 to the Engine Control Module -J623- harness connector T91 / 43 for resistance.
- CHECK: Oxygen Sensor 1 Before Catalytic Converter -GX10- harness connector terminal 2 to the Engine Control Module -J623- harness connector T91 / 44 for resistance.
- CHECK: Oxygen Sensor 1 Before Catalytic Converter -GX10- harness connector terminal 3 to the Engine Control Module -J623- harness connector T91 / 74 for resistance.
- CHECK: Oxygen Sensor 1 Before Catalytic Converter -GX10- harness connector terminal 5 to the Engine Control Module -J623- harness connector T91 / 41 for resistance.
- SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω).
-- Were Values obtained? |
-- YES:
-- NO:
|
| 6 |
- Final Procedure
- Perform a road test to verify repair.
-- Does the original DTC return? |
-- YES:
- CHECK: Engine Control Module -J623- harness connector for any damaged, pushed out pins.
- REPAIR: As necessary.
- If all electrical connections are OK:
- REPLACE: Engine Control Module -J623-.
- Clear the DTC's. Refer to DIAGNOSTIC MODE 04 - ERASE DTC MEMORY
.
- Repair is complete. Generate Readiness Code. Refer to READINESS CODE
.
- Return vehicle to Customer.
-- NO:
- Perform the diagnostic procedure for any DTC's.
- If no DTC's return the repair is complete.
- Return vehicle to customer.
|