Vehicle Electrical System Control Module -J519- DESCRIPTION
General Description
The Vehicle Electrical System Control Module -J519- is clipped to the bottom of the relay panel and can be removed.
The Vehicle Electrical System Control Module -J519- has the Following Functions in the Vehicle:
- Electric load management/exterior lighting control
- Turn signal control
- Windshield wiper and washer system
- Coding the Rain/Light Recognition Sensor -G397-
- Rear Window Defogger
- Interior light control
- Terminal control
- Dimming, instrument illumination
- Footwell lamps
- Fuel pump supply
- Pre-energizing of the generator
- Horn
- Warning lamp
- Release control
- Control central locking
- Activates front and rear door control modules
- Activates the rear lid remote unlock
- Activates the fuel filler door unlock
- Activates the anti-theft alarm system
- Immobilizer activation
- Activates the start authorization
- Adapts acoustic acknowledgment when unlocking
- Adapts acoustic acknowledgment when locking
- Adapts the blinking cycle during one-touch lane change signaling
- Automatic Unlocking when Removing Ignition Key, Adapting
- Adapts automatic locking at 15 km/h
- Adapts convenience locking confirmation
- Adapts coming home time
- Adapts leaving home time
- Adapts anti-theft alarm delay when opening the driver door
- Adapts single door opening
- Deactivates factory mode
- Adapts footwell illumination intensity
- Adapts Convenience operation via remote control
- Intelligent Alarm Horn, Adapting Market Version
- Adapts the visual acknowledgment when locking
- Remote Control Key, Adapting
- Remote Control Key, Checking
- Output diagnostic test mode for Vehicle Electrical System Control Module -J519-.
- Deactivates the Wiper Motor Control Module -J400- APP function
- Coding the Vehicle Electrical System Control Module -J519-
It depends on the vehicle equipment whether the adaptations listed above can be performed.
If the Vehicle Electrical System Control Module -J519- is to be replaced, the "Replace the vehicle electrical system control module" procedure must always be performed to read out the codes stored in the Vehicle Electrical System Control Module -J519-.
Malfunction Recognition and Malfunction Indicator
The Vehicle Electrical System Control Module -J519- is equipped with OBD.
For troubleshooting, use the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.