LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volvo >> 1993 >> 940 Base, 4D Sedan, AW70 >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Engine Controls - System/Component Tests) >> Computerized Engine Controls >> Electronic Control Unit - Fuel Injection (850) >> Preliminary Check & Measuring Unit Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Preliminary Check & Measuring Unit Installation

WARNING: This page is about a different car, the 1994 Volvo 960, 1994 Volvo 940, and 1994 Volvo 850. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove ECU cover located in right front engine compartment. Remove both fuel injection and distributor ignition ECUs. Press adapter into ECU base. Position adapter lead at rear of ECUs and thread through slot next to distributor ignition module.
  2. Press distributor ignition ECU into position first to avoid damage to adapter lead. Press fuel injection control unit, with adapter connected, into connector in bottom of ECU box. Connect measuring unit to adapter 60-pin connector.
scientia non olet · About LEMON Manuals