LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volvo >> 1993 >> 940 Base, 4D Sedan, AW70 >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Engine Controls - System/Component Tests) >> Computerized Engine Controls >> Electronic Control Unit - Ignition (850) >> Preliminary Check & Measuring Unit Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Preliminary Check & Measuring Unit Installation

WARNING: This page is about a different car, the 1994 Volvo 960, 1994 Volvo 940, and 1994 Volvo 850. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch to OFF position. Distributor ignition ECU is located in right side of engine compartment. Remove ECU cover. Disconnect distributor ignition ECU connector. Visually inspect all terminal connector sleeves to ensure no terminals are damaged.
  2. To install measuring unit, remove distributor ignition ECU. Press adapter onto distributor ignition ECU and pull lead upward through slot beside module. Press distributor ignition ECU, with adapter connected, into connector in bottom of ECU box. Connect measuring unit to adapter 60-pin connector.
scientia non olet · About LEMON Manuals