Removing the Sub-Frame

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Bolts, Washers And Brackets In Sub-Frame

Courtesy of VOLVO CARS OF NORTH AMERICA.

Position a lifting table under the sub-frame

Remove the following on both sides:

the screws holding the sub-frame brackets in the bodywork
the screw for the sub-frame mounting.

Hang up the engine block heater secured on the left-hand side of the sub-frame, if applicable.

Carefully lower the sub-frame.

NOTE: Ensure that the brake pipe clears the exhaust pipe mounting when lowering the frame.

NOTE: Ensure that the steering gear screws release from the sub-frame.