Checking Cables And Components, Infotainment Control Module (ICM)
WARNING: This page is about a different variant/trim than selected.
- Ignition off
- Disconnect the MOST cable connector from the infotainment control module (ICM)
- Ignition on
- Activate the infotainment system.
Check visually whether the infotainment control module (ICM) is emitting light from the MOST connector.
The control module is defective if the infotainment control module (ICM) is not emitting light.
If the infotainment control module (ICM) is transmitting light, the fault is in the MOST cable for the next control module.
Check the MOST connection. Check for dirt, loose connections and damage.
Replace the MOST cable if no fault is found in the MOST terminal.
Remedy as necessary.
Other information
- See: INFORMATION AND ENTERTAINMENT DISPLAY
- See: CHECKING THE SUPPLY VOLTAGE/GROUND TERMINAL
- See: SIGNAL SPECIFICATION
- See: FIBER OPTIC CABLE HARNESS, REPAIRING
- For information about location and order of control modules in the MOST network, See: LOCATION OF COMPONENTS
- Continue
See: VERIFICATION