Ignition Coil: Service and Repair

Ignition Coil Replacement

Removal Procedure





Caution: Refer to Battery Disconnect Caution Battery Disconnect Caution.

1. Disconnect the negative battery cable.
2. Disconnect the electronic ignition (EI) system ignition coil connector.
3. Note the ignition wire location and remove the ignition wires.
4. Remove the EI system ignition coil retaining bolts.
5. Remove the EI system ignition coil.

Installation Procedure





Notice: Refer to Fastener Notice Fastener Notice.

1. Install the EI system ignition coil into the mounting location and install the retaining bolts.

Tighten the electronic ignition system ignition coil retaining bolts to 10 Nm (89 lb in).

2. Connect the EI system ignition coil connector.
3. Install the ignition wires.
4. Connect the negative battery cable.