DTC 1302: GPS Receiver Error 1
NOTE:
- Check the vehicle battery condition first (see BATTERY TEST ).
- This navigation DTC sets when there is an internal GPS receiver problem.
- Check any official Honda service website for more service information about the navigation system.
- Before you troubleshoot, make sure to follow the General Troubleshooting Information (see GENERAL TROUBLESHOOTING INFORMATION ).
- Make sure the vehicle is parked outside, away from buildings.
- Aftermarket electronic devices located near the audio-navigation unit or GPS antenna can potentially interfere with the operation of the navigation system.
- Clear the hard error code (see HOW TO CLEAR ERROR HISTORY ).
- Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
- Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and wait at least 1 minute.
- Check for the hard error code (see HOW TO CHECK ERROR HISTORY (NAVIGATION DTCS)
).
Is DTC 1302 indicated?
YES -Go to step 5.
NO -Intermittent failure, the system is OK at this time.
- Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
- Check for poor connections or loose terminals at audio-navigation unit connector J (2P).
Are there connections or terminals OK?
YES -Replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ).
NO -Repair poor connections or loose terminals, and recheck. If the code continues to reset intermittently, replace the GPS antenna (see GPS ANTENNA REMOVAL/INSTALLATION ).