86 10... Removing rear supports and bracket

Release screws (1) and remove rear support (2) from bracket (3).

Installation:

Tightening Torque,

Fig 1: Identifying Rear Support With Bracket And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cable holders (1) from bracket (2). Release screws (3) on left and right sides of bracket (2). Drill out rivets (4) from underside of platform. Drill out rivets (5) from upper side of platform.

Installation:

Tightening Torque,

refer to 86 10 27AZ

Fig 2: Identifying Cable Holders, Bracket, Screws And Rivets

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Feed cable for rear light (1) through opening (2). Fit cable holders (4) in holes (3).

Fig 3: Fitting Cable Holders In Holes

Courtesy of BMW OF NORTH AMERICA, INC.