Top View/Reversing Camera Functions Intermittently (66 07 10)
Publication date: 2010-10-05Reference number: 66 07 10
TOP VIEW/REVERSING CAMERA FUNCTIONS INTERMITTENTLY
TECHNICAL SERVICE BULLETIN
| BMW: | E70 (X5); E71, E72 (X6); Vehicles produced from 9/30/09 up to 9/29/10 |
| GROUP: | Distance Systems, Cruise Control, Remote Control |
SUBJECT
Top View/Reversing Camera Functions Intermittently
SITUATION
Intermittently the top view and reversing camera (TRSVC) do not function after starting the vehicle. The PDC (Park Distance Control) system functions as designed. Fault codes E218 and E219 are stored in the PDC control module.
The top view and reversing camera functions are restored when the ignition is switched off and on again.
The situation occurs very intermittently.
CAUSE
Software error in the TRSVC control module.
PROCEDURE
Do not replace any parts! Parts replacement does not correct the issue.
- Program and code the vehicle using ISTA/P 2.39.0 or higher.
- Note that ISTA/P will automatically reprogram and code all programmable control modules that do not have the latest software.
- For information on programming and coding with ISTA/P, refer to CenterNet / Aftersales Portal / Service / Workshop Technology / Vehicle Programming.
WARRANTY INFORMATION
Covered under the terms of the BMW/SAV New Vehicle Limited Warranty as applicable.
Defect Code: 66 53 04 02 00
| Labor Operation: | Labor Allowance: | Description: |
|---|---|---|
| 00 00 006* | Refer to KSD2 | Perform vehicle test |
| 61 00 710+ | Refer to KSD2 | Program and Code with ISTA/P (w/o CAS) |
| 61 00 720+ | Refer to KSD2 | Program and Code with ISTA/P (with CAS) |
| Refer to KSD2 | Refer to KSD2 | Concluding work (initializations) as described in ISTA/P final report |
*Main Work - Only one main labor operation (ending with 000-499) may appear on any claim or group of claims (warranty, maintenance or campaigns) that are generated from the same repair visit.
All other labor operations on the same line or other lines must be claimed using plus code labor operations (KSD2 labor operations that have a (+) prefix and the last three digits are 500 or a higher number).
In cases where ISTA requires the replacement of control modules or additional programming because certain control modules failed to program correctly, or just an initialization is required, print out the Measures Plan and/or Final Report and attach these reports to the RO in the vehicle file. This additional work should be claimed under the defect code listed in this bulletin, using the labor operation and labor allowance from the KSD2.