New Delivery Stop: Program The Control Units "Electrical Machine Electronics" (12 39 15)
Publication date: 2015-11-01Reference number: 12 39 15
NEW DELIVERY STOP: PROGRAM THE CONTROL UNITS "ELECTRICAL MACHINE ELECTRONICS"
TECHNICAL SERVICE BULLETIN
| BMW: | F15 PHEV (X5 xDrive40e) |
| GROUP: | Engine Electrical Systems |
This Service Information Bulletin supersedes SI B12 39 15 dated November 2015.
Please perform the procedure outlined in this Service Information on all affected vehicles before customer delivery. In the event the customer has already taken delivery of the vehicle, please perform the procedure the next time the vehicle is in the shop.
SUBJECT
Delivery Stop: Program the Control Units "Electrical Machine Electronics"
SITUATION
The software in the Electrical Machine Electronics (EME) is incorrectly calibrated.
AFFECTED VEHICLES
Certain VINs (not all) produced between August 7 and October 19, 2015. Please check the key reader or the Warranty Vehicle Inquiry screen in DCSnet.
PROCEDURE
The vehicle can be sold after the following repair procedure is performed: Program and code the complete vehicle with ISTA/P 3.57.1 (Target I-Level 15-11-502) or higher.
WARRANTY INFORMATION
Reimbursement for this Service Action will be via normal claim entry utilizing the following information:
| Defect Code: | 00 12 12 04 00 |
| Labor Operation: | Labor Allowance: | Description: |
|---|---|---|
| 00 63 826 | 1 FRU | Programming and coding was performed previously in conjunction with another campaign or repair (vehicle is already at the specified "Target" integration level or higher, no repair is necessary) (Plus work) |
| Or: | ||
| 00 63 827 | 8 FRU | Program and code control units (includes connecting an approved battery charger/power supply and performing a vehicle test) (Plus work) |
Vehicle Programming and Encoding
If a control module was working properly and it fails to program correctly or requires initialization, please claim this additional work with the applicable KSD2 labor operations under the defect code listed above.
The diagnosis and repair of vehicles "arriving" with failed control modules or stored faults which will cause them to fail during programming cannot be claimed under the defect code listed in this bulletin.
Other Repairs
If other eligible and covered work is performed "prior" to programming and coding the vehicle, claim this work with the applicable defect code and labor operations listed in KSD2.