Personalization of the RKE

The automatic door lock feature enables under the following conditions:

• The ignition switch is in the RUN position.
• If any door is open.
• The vehicle shifts into the PARK position.

The BCM uses the signal from the receiver to either enable or disable the automatic door lock feature. Use one of the following two different ways to program the automatic door lock feature:

• Use the option register (the dealership uses a scan tool to program the automatic door lock feature) to enable or disable the automatic door lock feature for two FOBs (1st design) or four FOBs (2nd design).
• Perform the following steps to program the automatic door lock feature using the FOBs:
  1. Ensure the ignition switch is in the RUN position.
  2. Ensure the gear shift lever is in the PARK position.
  3. Press the brake pedal for the entire duration of the procedure.
  4. Press the transmitter UNLOCK button 4 times for about one second with less than 5 seconds between presses to disable the automatic door lock feature.
  5. Press the transmitter LOCK button 4 times for about one second with less than 5 seconds between presses to enable the automatic door lock feature.