Power Windows Inoperative - Lockout Function

Step	Action	Yes	No
Schematic Reference: Power Window Schematics
1	Did you perform the Power Door Systems Diagnostic System Check?	Go to Step 2	Go to Diagnostic System Check - Door Systems
2	Turn ON the ignition, with the engine OFF. Enable the window lockout function. Operate the passenger power windows from the passenger door power window switches. Do the passenger power windows operate UP and DOWN?	Go to Step 3	Go to TESTING FOR INTERMITTENT AND POOR CONNECTIONS
3	Check the master switch lockout signal circuit for a short to ground. Refer to CIRCUIT TESTING and WIRING REPAIRS . Did you find and correct the condition?	Go to Step 6	Go to Step 4
4	Inspect for poor connections at the harness connector of the master power window switch. Refer to TESTING FOR INTERMITTENT AND POOR CONNECTIONS and CONNECTOR REPAIRS . Did you find and correct the condition?	Go to Step 6	Go to Step 5
5	Replace the master power window switch. Refer to Power Accessory Switch Panel Replacement . Did you complete the repair?	Go to Step 6	-
6	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2