Test Description
WARNING: This page is about a different car, the 2004 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
The numbers below refer to the step numbers on the diagnostic table.
- 3: This DTC detects an open stop lamp switch signal circuit from the stoplamp side of the splice pack to the EBCM.
- 4: Verifies that the stop lamps are operating properly.
DTC C1295
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: ABS Schematics Connector End View Reference: ABS Connector End Views |
|||
| 1 | Did you perform the ABS Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - ABS |
| 2 |
|
Go to Step 4 | Go to Step 3 |
| 3 | Test the signal circuit of the stop lamp switch for an open or high resistance. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 7 | Go to Step 5 |
| 4 | Press the brake pedal. Are all of the stop lamps ON? |
Go to Step 5 | Go to Stop Lamps Inoperative |
| 5 | Inspect for poor connections at the harness connector of the EBCM. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 7 | Go to Step 6 |
| 6 |
IMPORTANT:
Perform the setup procedure for the EBCM. An unprogrammed EBCM will result in the following conditions: Replace the EBCM. Refer to Electronic Brake Control Module Replacement .Did you complete the repair?
|
Go to Step 7 | - |
| 7 |
|
Go to Step 2 | System OK |