LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1892 (Steering Linkage System) >> Repair Instructions >> Relay Rod Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Idler Arm & Relay Rod
    GM1862675Courtesy of GENERAL MOTORS CORP.
  1. Position the relay rod (5) in the vehicle.
  2. Install the pitman arm (2) to the relay rod (5).
  3. Install the idler arm (1) to the relay rod.
    4. CAUTION:

    Refer to Fastener Caution .

  4. Install a NEW pitman arm nut (4) and tighten to 62 N.m (46 lb ft).
  5. Install a NEW idler arm nut (6) and tighten to 62 N.m (46 lb ft).
  6. Install the steering linkage outer tie rods. Refer to Steering Linkage Outer Tie Rod Replacement .
  7. Install the steering linkage shock absorber to the relay rod, if equipped. Refer to Steering Linkage Shock Absorber Replacement .
  8. Install the engine shield, if equipped. Refer to Engine Shield Replacement .
  9. Measure the wheel alignment. Refer to Wheel Alignment Measurement .
  10. Adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .
scientia non olet · About LEMON Manuals