Steering Column Lock Control Module Replacement

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures With the vehicle in accessory mode, remove fuse to unlock the steering column lock control module - Column Lock Wiring Schematics Disconnect the electrical connector. Instrument Panel Knee Bolster Replacement Floor Front Air Outlet Duct Replacement - Left Side
1	Steering Column Lock Control Module Bolt [2x] CAUTION: Refer to Fastener Caution . Procedure Use a small hammer and chisel to remove and DISCARD the steering column lock control module bolts (1). Install the NEW steering column lock control module bolts (1) and tighten until the bolt heads break off. NOTE: Start ALL bolts by hand before breaking the bolt heads off or misalignment of the steering column lock control module may occur.
2	Steering Column Lock Control Module Bolt [2x] Tighten 9.5 N.m (84 lb in)
3	Steering Column Lock Control Module Procedure Program the steering column lock control module. K60 Steering Column Lock Module: Programming and Setup