Circuit/System Verification
- Ignition ON/Vehicle In Service Mode.
- Verify DTC U3000 is not set.
- If DTC U3000 is set with symptom byte 49 or 54.
- Perform all necessary programming and setup procedures for the control module that sets the DTC.
- Verify the DTC does not set.
- If the DTC sets, replace the control module that sets the DTC.
- Go to next step: If the DTC does not set
- All OK.
- If DTC U3000 is set active or in history with any symptom byte, except 49 or 54.
Replace the control module that sets the DTC.
- Go to next step: If DTC U3000 is not set
- All OK