Keyless Entry Receiver: Service and Repair

REMOVAL PROCEDURE
1. Remove the instrument panel cluster trim plate.
2. Remove the radio or the instrument panel storage compartment.
3. Disconnect the remote keyless entry receiver electrical connector.
4. Remove the bolts retaining the control module to the carrier.
5. Remove the module from the vehicle.

INSTALLATION PROCEDURE
1. Install the keyless entry control module to the vehicle.
2. Install the bolts retaining the control module to the carrier.
3. Connect the remote keyless entry receiver electrical connector.
4. Install the radio, or the instrument panel storage compartment to the vehicle.
5. Install the instrument panel cluster trim plate.
6. Reprogram the transmitter. Refer to Transmitter Programming. Service and Repair
7. Verify that the system operates properly.