Audible Warning Device Control Module: Service and Repair

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.

1. Disconnect the negative battery cable.
2. Remove the left sound insulator.
3. Remove the retaining nuts (4) from the alarm module (5).
4. Remove the multifunction alarm assembly (5) from the convenience center.

INSTALLATION PROCEDURE
1. Install the multifunction alarm assembly (5) to the convenience center.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the nuts (4) to the alarm module (5).

Tighten
Tighten the nuts to 6 N-m (53 lb in).

3. Install the left sound insulator.
4. Connect the negative battery cable.