System Check
NOTE:
If system does not function as specified, go to appropriate symptom test under SYMPTOM TESTS
.
- Sit in driver's seat and close driver's door. Turn ignition switch to RUN position. Leave driver's seat belt unbuckled. Fasten seat belt chime should sound 4-8 seconds. Buckle driver's seat belt. Fasten seat belt chime should not sound.
- Turn ignition switch to OFF position. Leave ignition key-in ignition switch. Open driver' door. Key-in ignition chime should sound 6-9 times within 3-4 seconds, then once every 3-4 seconds. Remove ignition key. Key-in ignition chime should not sound.
- With ignition switch in OFF position and driver's door open, turn headlight switch to PARK position. Lights on chime should sound 5 times per second. Turn headlight switch to OFF position, Lights on chime should not sound.
- Open front passenger's door. Courtesy lights should come on. Close all doors. Courtesy lights should go off.NOTE: Perform procedures in following step within 15 seconds. If chime and/or interior lights do not operate as specified, replace MAM. See MULTIFUNCTION ALARM MODULE (MAM) under REMOVAL & INSTALLATION.
- Set parking brake. Turn ignition switch to RUN position. Open front passenger's door. Cycle headlight switch from OFF to PARK position 3 times. MAM should not chime and interior lights should flash until ignition switch is turned to OFF position.
- After performing appropriate symptom test(s) and making repairs, repeat SYSTEM CHECK to ensure system is operational.