LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 1998 >> Corvette 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Keyless Entry System - Remote) >> Diagnostic Trouble Code Tests >> DTC B2805: No Transmitters Programmed
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC B2805: No Transmitters Programmed

WARNING: This page is about a different car, the 1997 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. If referenced to this test from RKE SYSTEM CHECK, go to next step. If not referenced to this test from RKE SYSTEM CHECK, go to RKE SYSTEM CHECK  under TROUBLE SHOOTING.
  2. Program transmitters. See TRANSMITTER PROGRAMMING & SYNCHRONIZATION  under SYSTEM PROGRAMMING. If programming procedure was successful, go to next step. If programming procedure was not successful, go to step 4).
  3. Clear DTCs. See CLEARING CODES  under SELF-DIAGNOSTIC TESTING. Using scan tool, check for RFA DTCs. If DTC B2805 is set current, go to step 7). If DTC B2805 is not set current, go to RKE SYSTEM CHECK  under TROUBLE SHOOTING.
  4. Program a known good transmitter. See TRANSMITTER PROGRAMMING & SYNCHRONIZATION  under SYSTEM PROGRAMMING. If programming procedure was successful, go to next step. If programming procedure was not successful, go to step 7).
  5. Inspect malfunctioning transmitter battery for improper installation, wrong battery or weak battery. If any of these battery conditions exist, go to next step. If these battery conditions do not exist, go to step 8).
  6. Replace transmitter battery. After replacing transmitter battery, go to step 2).
  7. Replace remote control door lock receiver. See REMOTE CONTROL DOOR LOCK RECEIVER  under REMOVAL & INSTALLATION. Program both transmitters. See TRANSMITTER PROGRAMMING & SYNCHRONIZATION  under SYSTEM PROGRAMMING. Program all Tire Pressure Monitor (TPM) sensors. See TPM SENSOR PROGRAMMING  under SYSTEM PROGRAMMING. Go to step 9).
  8. Replace malfunctioning transmitter. Program transmitter. See TRANSMITTER PROGRAMMING & SYNCHRONIZATION  under SYSTEM PROGRAMMING. Go to next step.
  9. Turn ignition off. Ensure all components and connectors are connected and installed properly. Turn ignition on. Clear DTCs. See CLEARING CODES  under SELF-DIAGNOSTIC TESTING. Go to RKE SYSTEM CHECK under TROUBLE SHOOTING.
scientia non olet · About LEMON Manuals