Manifold Pressure/Vacuum Sensor: Service and Repair

Manifold Absolute Pressure Sensor Replacement

Removal Procedure






Caution: Refer to Battery Disconnect Caution.

1. Disconnect the negative battery cable.
2. Remove the manifold absolute pressure (MAP) sensor electrical connector.
3. Remove the MAP sensor bolt.
4. Remove the MAP sensor.

Installation Procedure






Notice: Refer to Fastener Notice.

1. Install the MAP sensor with the bolt.

Tighten the MAP sensor bolt to 10 N.m (89 lb in).

2. Connect the MAP sensor electrical connector.
3. Connect the negative battery cable.