Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2006 GMC Savana Special, 2006 GMC Savana Camper Special, 2006 GMC Savana, 2006 Chevrolet RV Cutaway, and 2006 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing BCM Into Bracket

Courtesy of GENERAL MOTORS CORP.

Install the BCM (1) into the bracket.
Ensure the BCM (1) is engaged in the bracket, under the retaining tabs (2).

Fig 2: Disconnecting Electrical Connectors From Body Control Module

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connectors (2) to the BCM (1).

Fig 3: Removing Right Side Knee Bolster Trim Panel

Courtesy of GENERAL MOTORS CORP.

Install the right side knee bolster trim panel. Refer to Knee Bolster Replacement - Right in Instrument Panel, Gages, and Console.
If you replaced the BCM, program the module. Refer to Body Control Module (BCM) Programming/RPO Configuration .