Manifold Absolute Pressure Sensor Replacement (SCIP)

Manifold Absolute Pressure Sensor Replacement (SCIP)

Removal Procedure




1. Disconnect the supercharger inlet pressure (SCIP) sensor harness connector.
2. Remove the SCIP sensor (1) from the supercharger.

Important: If the SCIP sensor seal is damaged, the SCIP sensor must be replaced.

3. Inspect the seal for damage.

Installation Procedure






Notice: Refer to Fastener Notice.

Important: Use the new SCIP sensor seal provided with the new SCIP sensor.

1. Install the SCIP sensor (1) into the intake manifold.

Tighten the bolt to 10 N.m (89 lb in).

2. Connect the SCIP sensor harness connector.