Scan Tool Data Definitions

Scan Tool Data Definitions
Accy. Indicator Command
- The scan tool displays the status of the accessory indicator.

Accy. Relay Command
- The scan tool displays the status of the accessory output.

Auxiliary Power
- The scan tool displays the status of the auxiliary power relay.

Battery Voltage Signal
- The scan tool displays 0.0-16.0 volts. The battery voltage input represents the system voltage measured at the module ignition feed input.

Brake Apply Sensor Reference Signal
- The scan tool displays the voltage read by the brake apply sensor.

Current Power Mode
- The scan tool displays the current power mode.

Idle Boost Level
- The scan tool displays the level of the idle boost.

Ignition Cycle Counter
- The scan tool displays the ignition cycle counter.

Ignition Mode Switch
- The scan tool displays the voltage and the state read by the module from the ignition mode switch.

Ign. Mode Sw. Dimming Command
- The scan tool displays the status of the ignition mode switch dimming.

Inadvertent Power Cmd.
- The scan tool indicates the status of the inadvertent power command.

Inadvertent Power Signal
- The scan tool displays the status of the inadvertent power signal.

Key in Cylinder Switch
- The scan tool displays if the key is in the trunk cylinder switch.

Off Indicator Command
- The scan tool displays the status of the off indicator.

Run/Crank Relay Command
- The scan tool displays if the run/crank relay is controlled or not by the module.

Start Indicator Command
- The scan tool displays the status of the start indicator.