Computer/Integrating Systems Schematic Icons

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2006 GMC Savana Special, 2006 GMC Savana Camper Special, 2006 GMC Savana, 2006 Chevrolet RV Cutaway, and 2006 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Icon	Icon Definition
Courtesy of GENERAL MOTORS CORP.	CAUTION: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling Zones. Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs.
Courtesy of GENERAL MOTORS CORP.	IMPORTANT: Twisted-pair wires provide an effective shield that helps protect sensitive electronic components from electrical interference. In order to prevent electrical interference from degrading the performance of the connected components, you must maintain the proper specification when making any repairs to the twisted-pair wires shown : The wires must be twisted a minimum of 9 turns per 31 cm (12 in) as measured anywhere along the length of the wires. The outside diameter of the twisted wires must not exceed 6.0 mm (0.25 in).

Icon

Icon Definition

Courtesy of GENERAL MOTORS CORP.

CAUTION: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling Zones. Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs.

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Twisted-pair wires provide an effective shield that helps protect sensitive electronic components from electrical interference.
In order to prevent electrical interference from degrading the performance of the connected components, you must maintain the proper specification when making any repairs to the twisted-pair wires shown :

The wires must be twisted a minimum of 9 turns per 31 cm (12 in) as measured anywhere along the length of the wires.
The outside diameter of the twisted wires must not exceed 6.0 mm (0.25 in).