Alignment Checking

Alignment Checking


Tram Gauge Method

-Use a tram gauge as a quick reference in order to determine vehicle damage. Use a tram gauge set with a vertical pointer capable of reaching 914 mm (36 in).

-Make the engine compartment component measurements from point to point with the vertical pointers equally set.

-Make the other measurements on the horizontal plane, or the datum line, parallel to the underbody with the vertical pointers set as specified for each point.

-Measure dimensions that are measured to the gauge holes to the center of the holes and flush to the adjacent surface metal unless otherwise specified. Cross-check the diagonal dimensions in order to verify the dimensional accuracy of the vehicle underbody.

3-Dimensional Method

-Measure following multiple points when measuring structural repair with repair equipment:

-The length

-The height

-The width

-Measure 2/3 of the vehicle body in order to obtain accurate comparisons to the vehicle structure.

-Universal measuring systems combine the equipment and the techniques used to make the underbody 3-dimensional measurements. The universal system provides accurate measurements of the following points:

-The length

-The width

-The height