Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disconnecting/Reconnecting Battery Current Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Disconnect the battery current sensor electrical connector (2).
Remove the battery negative cable from the vehicle. Refer to Battery Negative Cable Replacement .
Remove the tape (3) securing the battery current sensor (1) to the negative battery cable (4).

Fig 2: Identifying Battery Current Sensor

Courtesy of GENERAL MOTORS CORP.

Remove the battery current sensor (2) from the ground end of the negative battery cable (1).