LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 450 (Wiper System & Washer System) >> Repair Instructions >> Wiper Drive System Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Wiper Motor Assembly
    GM1206780Courtesy of GENERAL MOTORS CORP.
  1. Install the wiper motor. Refer to Wiper Motor Replacement .
    2. Fig 2: View Of Electrical Connector And Wiper Motor
    GM1326390Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connector to the wiper motor.
  3. Connect the clip retaining the electrical harness to the wiper module.
    4. Fig 3: View Of Wiper Drive System Module
    GM1201895Courtesy of GENERAL MOTORS CORP.
  4. Position the wiper module assembly into the plenum.
    5. NOTE: Refer to Fastener Notice .
  5. Install the fasteners attaching the wiper module assembly to the plenum.

    Tighten:  Tighten the fasteners to 10 N.m (89 lb in).

  6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  7. Install the wiper arms. Refer to Wiper Arm Replacement .
  8. Inspect the washers for proper operation.
scientia non olet · About LEMON Manuals