LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Cutaway 6.6 L >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Antilock Brake System With Traction Control System & Stability Control System) >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 GMC Savana Special, 2010 GMC Savana Camper Special, 2010 GMC Savana, 2010 Chevrolet RV Cutaway, and 2010 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Carefully align and install the EBCM (1) to the BPMV. Do not force the components together.
    Fig 1: Identifying EBCM & BPMV
    GM2001464Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
    Fig 2: Identifying EBCM Bolts
    GM2001462Courtesy of GENERAL MOTORS CORP.
  2. Install new EBCM bolts (1). Tighten the bolts in a cross pattern to 3 N.m (27 lb in).
  3. Connect the electrical connector to the EBCM.
  4. Install the brake modulator shield and the mounting nuts, if equipped, and tighten to 25 N.m (18 lb ft).
  5. Install the brake modulator shield mounting bolt and tighten to 25 N.m (18 lb ft).
  6. Lower the vehicle.
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  8. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals