LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Equinox LS, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 2.4L - DTC P0300 Through P1682 >> DTC P0650 >> Circuit/System Testing
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Circuit/System Testing

  1. Ignition OFF, disconnect the X1 harness connector at the K20 ECM.
  2. Ignition ON, the MIL should not illuminate.
    • If the MIL is illuminated, test the MIL control circuit terminal 46 X1 for a short to ground. If the circuit tests normal, replace the P16 instrument panel cluster.
  3. Connect a 3 A fused jumper wire between the MIL control circuit terminal 46 X1 and ground. The MIL should illuminate.
    • If the MIL illuminates, replace the K20 ECM.
    • If the MIL does not illuminate, test the MIL control circuit terminal 46 X1 for a short to voltage or an open/high resistance. If the MIL control circuit tests normal, test the instrument panel cluster ignition voltage circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the P16 instrument panel cluster/bulb.
scientia non olet · About LEMON Manuals