LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Impala LT >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 3.5L - DTC P0010 Through DTC P0340 >> DTC P0112 or P0113 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the B75B MAF/IAT sensor.
  2. Ignition OFF, all vehicle systems OFF, this may take up to 2 minutes, test for less than 5 Ω between the low reference circuit terminal D and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the K20 ECM.
  3. Ignition ON, verify the scan tool IAT parameter is colder than -39°C (-38°F).
    • If warmer than the specified range, test the signal circuit terminal E for a short to ground. If the circuit tests normal, replace the K20 ECM.
  4. Install a 3 A fused jumper wire between the signal circuit terminal E and ground. Verify the scan tool IAT parameter is warmer than 149°C (300°F).
    • If colder than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the K20 ECM.
  5. If all circuits test normal, test or replace the B75B MAF/IAT sensor.
scientia non olet · About LEMON Manuals