Brake Pedal Position Sensor Replacement

WARNING: This page is about a different car, the 2010 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Brake system does not use a brake switch, stoplight switch or brakelight switch. System uses a Brake Pedal Position Sensor to control these functions.

Fig 1: Brake Pedal Position Sensor

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Brake Pedal Position Sensor Assembly Tip: Disconnect the electrical connector.
2	Brake Pedal Position Sensor Bolt CAUTION: Refer to Fastener Caution . Tip: Calibrate the position sensor. Refer to Brake Pedal Position Sensor Calibration . Do not reuse the position sensor or bolt. Always use a new sensor and bolt. Tighten: 2 N.m (18 lb in)

Callout

Component Name

Brake Pedal Position Sensor Assembly
Tip: Disconnect the electrical connector.

Brake Pedal Position Sensor Bolt

CAUTION: Refer to Fastener Caution .

Tip:

Calibrate the position sensor. Refer to Brake Pedal Position Sensor Calibration .
Do not reuse the position sensor or bolt. Always use a new sensor and bolt.

Tighten: 2 N.m (18 lb in)