LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2016 >> Impala Limited LT >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup - All Systems >> Repair Instructions >> Electronic Brake Control Module Programming and Setup >> Replace and Program Control Module or Reprogram Control Module
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Replace and Program Control Module or Reprogram Control Module

To program a replacement or an existing Electronic Brake Control Module (EBCM), perform the following procedure:

  1. Install EL-49642  SPS Programming Support Tool.
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select Electronic Brake Control Module - Programming and follow the on-screen instructions.
  4. On the SPS Supported Controllers screen, select Electronic Brake Control Module - Configuration and follow the on-screen instructions.
  5. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
  6. With a scan tool, perform the Steering Angle Sensor Centering. Refer to Steering Wheel Angle Sensor Centering .
  7. With a scan tool, perform the Yaw Rate Sensor Recalibration. Refer to Vehicle Yaw Sensor Learn .
scientia non olet · About LEMON Manuals