Installation Procedure

WARNING: This page is about a different car, the 2022 Chevrolet Bolt EUV. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Remote Control Door Lock Receiver (2) - Install
Electrical Connector (1) - Connect
Courtesy of GENERAL MOTORS COMPANY

Quarter Lower Rear Trim Panel (1) - Install
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Feed the rear seat belt through the body lock pillar upper trim panel.

Body Lock Pillar Upper Trim Panel (3) - Install
Quarter Window Trim Finish Panel Bolt (2) - Install and tighten - Fastener Specifications
Quarter Window Trim Finish Panel Bolt Cap (1) - Install
Rear Seat Back Cushion - Install - Rear Seat Back Cushion Removal and Installation (40 Percent Seat) , or Rear Seat Back Cushion Removal and Installation (60 Percent Seat)
Courtesy of GENERAL MOTORS COMPANY

Rear Seat Back Bolster (2) - Install
Rear Seat Back Bolster Nut (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Rear Side Door Sill Garnish Molding (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear Seat Cushion (1) - Install - Rear Seat Cushion Removal and Installation
Courtesy of GENERAL MOTORS COMPANY

Connect the electrical connector.
Rear Compartment Courtesy Lamp (1) - Install
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Both sides shown. The quantity is for the one side.

Cargo Tie Down Loop (2) - Remove
Cargo Tie Down Loop Fastener (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Liftgate Sill Garnish Molding (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear Compartment Stowage Shelf (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear Compartment Stowage Shelf (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Luggage Shade (1) - Install
Enable the SIR System. SIR Disabling and Enabling