LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 1999 >> LHS >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> Windshield Wiper Test 10A >> Wipers Operate In High Speed Only
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Wipers Operate In High Speed Only

NOTE: Perform WINDSHIELD WIPER TEST 1A  before proceeding with this test. For connector terminal identification and wiring diagrams, see BODY CONTROL COMPUTER - INTRODUCTION article. Perform VERIFICATION TEST: VER-2A  after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
  1. Remove HI/LO relay from Power Distribution Center (PDC). See Figure. PDC is located in engine compartment. See Figure. Using external voltmeter, measure voltage between terminals "B" and "C" on HI/LO relay socket. Turn ignition on. Turn wiper switch to LOW speed position. If voltage is 9 volts or less, replace HI/LO relay. If voltage is greater than 9 volts, go to next step.
  2. Disconnect Body Control Module (BCM) Bone 12-pin connector C3. BCM is mounted to junction block located behind left end cap of instrument panel. See Figure.
scientia non olet · About LEMON Manuals