LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1998 >> Caravan Base, 2.4 B >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> Body Control Computer Tests >> Information Center Test 5B - Turn Signal Indicator Light
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Information Center Test 5B - Turn Signal Indicator Light

NOTE: Perform INFORMATION CENTER TEST 5A  before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION  . For wiring diagrams, refer to WIRING DIAGRAMS  . Perform, after each repair, VERIFICATION TEST VER-1A - VERIFICATION PROCEDURE  .
CAUTION: Always turn ignition switch to OFF position prior to disconnecting any module connector.
  1. Turn ignition off. Disconnect Body Control Module (BCM). BCM is located with junction block under driver's side instrument panel. See Figure . Access junction block internal 23-pin connector. Turn ignition on. Turn on right turn signal. Using test light, probe internal connector, terminal No. 21. If test light does not flash, repair or replace junction block. If test light flashes, go to next step.
  2. Turn on left turn signal. Using test light, probe internal connector, terminal No. 19. If test light does not flash, repair or replace junction block. If test light flashes, replace BCM.
scientia non olet · About LEMON Manuals