VTSS Test 10A - Loss Of Ignition Run To CTM

NOTE: Perform VTSS TEST 1A before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION . For wiring diagrams, refer to WIRING DIAGRAMS . Perform, after each repair, VERIFICATION TEST VER-1A - VERIFICATION PROCEDURE .

CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.

Locate Central Timer Module (CTM). CTM is located behind right kick panel. Disconnect CTM 14-pin Green connector "A". Using an external voltmeter, measure voltage between ground and CTM 14-pin Green connector "A" terminal No. 8 (Dark Blue wire). If voltage is more than 10 volts, replace CTM. If voltage is 10 volts or less, repair open Dark Blue wire between CTM and RUN-ACC fuse in junction block.