LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1998 >> Durango 5.9 Z, Part Time >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> Body Control Computer Tests >> VTSS Test 5A - Door Unlock Switch Failure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

VTSS Test 5A - Door Unlock Switch Failure

NOTE: Perform VTSS TEST 1A  before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION  . For wiring diagrams, refer to WIRING DIAGRAMS  . Perform, after each repair, VERIFICATION TEST VER-1A - VERIFICATION PROCEDURE  .
CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
  1. Clear trouble codes as needed. Using scan tool, read I/O's door unlock switch status. If scan tool displays RELEASED, system is currently functioning properly. If scan tool does not display RELEASED, go to next step.
  2. Disconnect left door lock switch connector. If scan tool displays RELEASED, replace left door lock switch. If scan tool does not display RELEASED, go to next step.
  3. Disconnect right door lock switch connector. If scan tool displays RELEASED, replace right door lock switch. If scan tool does not display RELEASED, go to next step.
  4. Locate Central Timer Module (CTM). CTM is located behind right kick panel. Disconnect CTM 18-pin connector "B". Using an external voltmeter, measure voltage between ground and CTM 18-pin connector "B" terminal No. 13 (Orange/White wire on Dakota and Pink/Violet wire on Durango). If voltage is more than 1.5 volts, repair short to voltage in Orange/White wire on Dakota and Pink/Violet wire on Durango between CTM and door lock switch. If voltage is 1.5 volts or less, replace CTM.
scientia non olet · About LEMON Manuals